Filter
Top Products
Instructions for the installer
4)
2.2 Attachment to support structure, flush-mounting model
Create an opening with the dimensions
shown in the figure in the work surface,
observing a minimum distance of 50 mm
from the rear edge.
1)
The lower part of the protective cover
must be fully accessible when the
appliance is installed. This appliance can
be installed next to walls that are higher
than the work surface, as long as the
distance "X" is kept, as shown in the
figure, to avoid damage from overheating.
Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf
that may be installed directly above them.
This type of appliance also requires a cut 3 mm deep in the work-top with the
dimensions shown in figure 4 (detail A, figure 2). Before positioning the hob, position
the adhesive sponge material “E” supplied over the milled surface (fig. 2-3). Having
done this, place the hob on the milled surface and using the screws and fixing brackets
“C” or “D” (depending on the depth of the worktop) secure the hob to the support
structure, ensuring it is level. The brackets “C” secure the hob to a structure having a
depth of 20 to 30 mm. The brackets “D” on the other hand, are for use with worktops
having a depth of 30 to 50 mm.
23