Filter
Top Products
Instructions for the installer
20
9.3 Overall dimensions
The overall dimensions of the appliance when open and closed are specified below.
9.4 Positioning the hotplate
There are a few things to bear in mind when positioning the
hotplate.
Leave a distance of at least 50 mm between the appliance and the
rear and side walls.
Surfaces close to the appliance must be of non inflammable
material or covered with a non-flammable heat insulating material.
Pay particular attention to fire prevention measures.
If two hotplates are positioned side by side, leave a gap of at least 6-
7 mm between them.
They can also be connected using the special bracket and screws
provided with each product. There are two holes at the front
underneath the hotplate specially for joining the appliances
together, maintaining the minimum safety distance.
9.5 Levelling the hotplate
The hotplate is equipped with height-adjustable feet front and back.
It is advisable to leave the rear section slightly higher so that the product tilts forward, allowing grease
and cooking juices to run to the front of the hotplate and drain through the hole into the drip tray, which
can then be removed and washed separately.