Filter
Top Products
Instructions for the user
52
8.2 Removing the door
8.2.1 With type 1 mobile levers
With the door completely open, lift the levers A of the two hinges until
they touch the hinges B and take hold of the two sides of the door with
both hands close to the hinges themselves. Raise the door to an angle of
about 45° and remove it. If the hinges have not locked, repeat the
operation, raising the levers and keeping the door slightly raised. To
reassemble, fit the hinges B into their grooves, then lower the door into
place, ensuring that it remains fitted into the grooves C, and lower the
levers A.
8.2.2 Removing doors with pins
Open the door completely and insert the pins (supplied) into the holes
from the inside. Close the door to an angle of about 45° and lift it off. To
reassemble, fit the hinges into their grooves, then lower the door into
place and extract the pins. If you should lose the pins, two screwdrivers
can also be used.
8.3 Oven door seal
To permit thorough cleaning of the oven, the seal
may be removed. Before removing the seal, take off
the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown
in the figure.
After cleaning, refit the seal with the longer side
horizontal and insert the tabs into the appropriate
holes starting from the top ones.