Filter
Top Products
Instructions for the user
30
9.4 What to do if...
The oven display is completely off
• Check the mains power supply.
• Check whether an omnipolar switch upstream from the oven feed
line is in the “ON” position.
The oven does not heat up
• Check whether the “showroom” mode has been set, for further
details see paragraph “Secondary menu” on page 17.
The controls do not respond.
• Check whether the “child lock-out function” mode has been set,
for further details see paragraph “Secondary menu” on page 17.
The cooking times are longer
than those indicated in the table.
• Check whether the “PO” mode has been set, for further details
see paragraph “Secondary menu” on page 17.
After the automatic cleaning
cycle it is not possible to select
a function.
• Verify whether the door interlock device has turned off. If it has
not, the oven has a protection device that does not allow
functions to be selected while the door interlock device is active.
This is because the temperatures inside the oven are still too
high to allow any type of cooking.
The display shows ERR 4
• The door interlock device has not hooked to the door properly.
This might be because the door was accidentally opened during
its activation. Turn off the oven and turn it on again waiting a few
minutes before selecting a new cleaning cycle.
The fans stop when the door is
opened during a convection
function.
• This is not a fault. It is a normal operation of the appliance,
useful when cooking foods in order to avoid excessive heat from
escaping. When the door is closed, the oven will return to normal
operation.