Smeg SNZ90MFX Range User Manual


 
Instructions for the user
18
13.EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals,
bulbs, and so on. The following instructions describe how to carry out these minor maintenance
operations.
Before any intervention, disconnect the power supply of the device.
13.1 Lubrication of the taps
In time the taps may be difficult to turn or may be blocked. Clean them inside and replace the lubrication
grease. This operation should be carried out by a specialised technician.
13.2 Replacement of light bulb
Remove cover A by twisting anticlockwise, replace bulb B with another similar bulb (25 W). Refit the
cover A.
Only use oven bulbs (T 300°C).
13.3 Removing the door
Hold the door on both sides with both hands near hinges A and
raise levers B. Lift up the door forming an angle of about 45° and
remove. To refit, slide the hinges A in the grooves, drop the door
and release levers B.
13.4 Oven door gaskets
To permit thorough cleaning of the oven, the seal may be removed. Before
removing the seal, take off the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown in the figure.