Filter
Top Products
Instructions for the installer
11. EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts subject to wear such
as seals, bulbs, and so on. The following instructions describe how to carry out these minor
maintenance operations.
Before any intervention, disconnect the power supply of the device.
11.1 Replacement of light bulb
Remove cover A by twisting anticlockwise, replace bulb B with another similar bulb (25 W).
Refit the cover A.
Only use oven bulbs (T 300°C).
11.2 Removing the door
Hold the door on both sides with both hands nea
r
hinges A and raise levers B. Lift up the door forming
an angle of about 45° and remove. To refit, slide the
hinges A in the grooves, drop the door and release
levers B.
11.3 Oven door seal
To permit thorough cleaning of the oven, the seal may be removed. Before
removing the seal, take off the door as described above. Once the door
has been taken off, lift the tabs at the corners as shown in the figure.
11.4 Lubrication of the taps
In time the taps may be difficult to turn or may be blocked. Clean them inside and replace the
lubrication grease. This operation should be carried out by a specialised technician.
2
6