Filter
Top Products
5
7. TECHNICAL DATA
This appliance meets the provisions of the
following directives:
89/336/EEC (electromagnetic compatibility),
73/23/EEC (electrical equipment designed for
use within certain voltage limits) as amended.
Household appliances sold in the EU also meet
96/57/EEC (energy efficiency requirements) as
amended.
The rating plate, which is placed either at the
back or inside the appliance, see fig. (7) page
7, provides various technical information as
well as type and serial number.
8. INSTALLATION
See drawings (1) and (2) page 6.
Install the cabinet in a dry place and so that it
is not exposed to direct sunlight or any other
source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base. The cabinet
should not rest against a wall on its hinged
side. When placing the cabinet on a carpet or
on a wooden floor, the placing should be
checked after a while to see whether the unit
has „subsided“ into the soft flooring.
The cabinets can be built in or put side by
side, see fig. (2b) page 5.
KF models put side by side with other models
require a distance of 2 inches between the
appliances.
For sufficient airflow around the cabinet it is
necessary to have a 4inches high air duct
right above the appliance, see fig. (2a) and
(2b) or an air duct that leeds the air up over
the top cupboard, see fig. (2c).
Make sufficient space for door opening as to
draw the baskets out, see fig. (2e).
The dimensions for building in are noted on
the drawings.
It is safest to place the earthed wall socket
above the appliance and at least 2.0 m above
the floor.
Any local installation rules for appliances of
this kind must be observed.
During a storm the electricity supply might be
cut off.
You should be aware of this when installing
the appliance in weekend cottages or else-
where where you would not immediately
observe that the power has been cut off.
Construction and details in the accessories
are subject to alteration without previous
notice.
If the cabinet is to be adjusted:
See drawings (1) page 6
Take hold of the front panel with both hands.
Then lift up the front panel and turn out the
bottom part.
Adjust the tilt of the unit
See drawings (1) page 6
by turning the adjustable feet with a 13 mm
spanner.