Filter
Top Products
Removing, Installing, and Replacing Components
45
Installing a 5¼” Internal Hard Disk Drive
Your system comes with an available 5¼” bay to hold an additional 3½”
or 5¼” hard disk drive. The drive you install can access the front panel.
The hard disk drive access light blinks when either internal drive is
active.
1 Configure the jumpers on the new drive as a secondary slave (see
your drive’s documentation for configuration instructions).
2 Disconnect the power cord from the computer.
3 Remove the cover (see “Removing the Cover” on page 22).
4 Remove the front panel (see “Removing the Front Panel” on page 24).
5 Lay the system on its side (see following diagram).
! Before opening the system unit, save any open files, exit the Windows
®
operating system, turn off the power of the computer and all attached
peripherals, and then unplug the power cord.
KY0084.VSD
Drive connector
Power connector
Jumpers