Filter
Top Products
INSTALLATION HEAVY DUTY COUNTERLINE
Step 2a: Installation on Countertop Legs
To install the appliance using co untertop legs, do the following:
1. Locate the box of four legs shipped with the appliance (if countertop legs were ordered).
2. Raise the appliance about 6" so that the legs can be screwed into the bottom near the corners. Lift the
appliance only from the ends, never from the middle! Support the lifted appliance so that it will not fall
while you are attaching the legs.
INSTALLATION
3. Screw the four legs into the threaded holes located on the bottom of the appliance near each corner
(as shown in Figure 5 below).
4. Gently lower the appliance onto the counter. Level the appliance surface by screwing one or more of
the legs in or out.
5. Go on to Step 4 on page 18.
Figure 5
PAGE 10 OPERATOR’S MANUAL 1182845 REV 6