Filter
Top Products
HEAVY DUTY COUNTERLINE INSTALLATION
Step 2e: Installation on Floor Stand (60" Models)
A 60" griddle may be installed on top of an optional floor stand (for 24", 36", and 48" griddles, go to Step 2d
on page 13). The floor stand is shipped in a separate crate and mu st be assembled, as follows:
1. Position the bottom-brace pieces on a flat surface, as shown in Figure 10 below. There are four
bottom-side braces (items “A”), and four front/rear bottom-braces (items “B”).
2. Position a corner brace (item “C”) in each interior corner, matching the pre-punched holes on the lower
inside flange of the bottom braces.
INSTALLATION
3. Position the six leg brackets (item “D”); one in each corner of the stand, one front-center, and one rear-
center, as shown in Figure 10. Be sure that the bracket flanges are engaged into the open hem of the
bottom braces.
4. Use the thirty-two 1/2"-long hex head bolts (items “E”), lock washers (items “F”), and acorn nuts (items
“G”) to bolt the corner braces to the bottom braces. Only hand-tighten for now.
5. Check that the leg bracket s are in the p roper position, and that the outside corners are square .
Figure 10