Southbend P16C-C Range User Manual


 
PLATINUM SERIES SECTIONAL RANGE SERVICE
INSTALL AND OPERATIONS MANUAL 1185836 REV 3 (07/06) PAGE 35 OF 80
Pilot-flame outage is often due to an unstable flame caused by over-adjustment to the point where the pilot flame is
leaving its port, or “blowing off.” Sometimes the pilots are increased too much in an effort to improve ignition, resulting
in this unstable condition.
Fi
g
ure 17
Adjustment of Charbroiler, Standard-Griddle, and Uniform Hot-Top Burners and Pilots
The burner valves are not adjustable. The burner orifice is of the fixed type, sized for the type of gas and the operating altitude.
To adjust the burner air-gas mixture, loosen the screw that secures the air shutter on the mixer face and rotate the mixer cap
to obtain a clear, stable blue flame with a distinct inner cone at each port. Excessive primary air causes “blowing” (the flames
leaving the ports), while insufficient primary air causes a soft or yellow tipped flame.
The pilots are near the front of the burners, and are held in position by brackets. To adjust a pilot flame, insert a screwdriver
through the opening in the valve panel between the control knobs and turn the appropriate pilot adjustment screw
counterclockwise to increase the size of the pilot flame, or clockwise to decrease the size of the pilot flame. The maximum
flame size is approximately 3/4" with a slight yellow tip. The first indication of over-adjustment is when the flame tip becomes
more yellow and begins to generate carbon, which appears as rising black streaks. Continued over-adjustment leads to
unstable lifting and a blowing condition.
Adjustment screw for left-burner pilot
Air Shutter
Access hole
for pilot
adjustment
Adjustment screw for right-burner pilot
Pilots