Filter
Top Products
RADIANT STEAKHOUSE BROILER INSTALLATION
STEP 2B: ATTACH COUNTERTOP LEGS
The broiler may set on a countertop using short legs. Be sure that the countertop is rated to support the crated weight
of the broiler (see Figure 2 on page 5). The model number is shown on the serial plate located in the rear right corner
of you broile
r (see Figure 1 on page 3).
1.
With the broiler lying on its back side, screw the four legs tightly into the leg pads, as shown below. Lift the broiler
(using two people is recommended) and set it in place on the countertop. Adjust the legs as needed to level unit.
2. Position the broiler to the specified minimum clearances (see page 4).
3.
Go on to Step 3.
Figure 5
Installation on Countertop
Screw legs into leg pads here.
OWNER’S MANUAL 1190950 (02/09) PAGE 13 OF 20