Sterling 015 Blender User Manual


 
Continuous Loss-in-Weight Blenders Chapter 3: Installation 30
Final Connections
1. Connect the blender to the appropriate power source.
2. Connect the compressed air piping, ensuring that a 5-micron air filter is installed,
along with the proper water trap, and lubrication unit, if required. Verify that 60 psi
(4.14 bar) of clean, dry compressed air is supplied to the blender.
Note: Again, make sure that proper air supply connections are made to the blender,
as dirty, contaminated, wet air can damage blender components and can
quickly cause poor performance and accuracy!
Note: Make sure that the blender is supplied with clean, dry,
60 psi (4.14 bar) compressed air.