Filter
Top Products
Continuous Loss-in-Weight Blenders Chapter 6: Appendix
60
PID Integral Constant
Works the same as the Gain.
Feeder Speed Limits
This allows you to set the minimum and maximum speed for the motor drives as a percentage.
The drives are not supposed to be run at less than 8 hertz and should not be run above 115
hertz.
Extruder RPM Options
This gives you the option of having no extruder speed input, writing the extruder speed to the
blender through the Ethernet, or using a proximity sensor on the end of the extruder screw.