Filter
Top Products
Continuous Loss-in-Weight Blenders Chapter 3: Installation 34
Touch “Scale” button
Find your calibration weight that shipped with the blender and locate the Weight information
stamped on the weight proceed as follows.
1. Enter weight value stamped on the weight in Cal Wt Box.
2. Make sure weigh hopper is empty then touch Set Zero.
3. Hang Calibration weight on weigh hopper and touch Set Cal Wt.
4. Repeat for all Hoppers including Mass Flow.
5. Touch done when complete
You can also check the calibration by looking at the in LBS box and hanging your calibration
weight on the weigh hopper to be checked.
Feeder Calibration
This section will explain how to calibrate the feeders on your OL blender. This must be done
on initial startup and whenever material is change and bulk density varies greatly. You must
make sure that the feeder to be calibrated has resin available. ****Also note that resin will be
dispensed into the Mass Flow hopper during this procedure.****