Filter
Top Products
BJ5-615 Chapter 5: Maintenance 45 of 85
WARNING! Danger of cutting caused by sharp cutters at all times—even when rotor is
at standstill. Serious Injury especially to the hands and fingers can occur. Wear
protective gloves!
Dismounting the Bed Cutters
1. Switch OFF the shredder at the main switch.
2. Safeguard main switch using a padlock.
3. Open the upper hopper door.
4. Safeguard the hopper door.
NOTE: Although it is possible to reach the cutters by climbing into the feeding
chamber, it is recommended to access the cutters through the front side door.
5. Clean the hexagon head socket of the cutter mounting screws (2) and the cover plates
mounting screws.
6. Loosen the cover plate mounting screws using a high quality Allen key (10 mm). Knock
the Allen key lightly with a hammer to loosen if necessary.
7. Take out the screws and cover plates.
8. Loosen the cutter adjusting screws for pulling and take them out.
9. Loosen the cutter mounting screws with Allen key (10 mm). Use a hammer to lightly
knock key if necessary.
10. Take out the cutter mounting screw and cutter.