Stoelting F144 Blender User Manual


 
13
Figure 20. Auger Flight Wear and Front Auger
Support Bushing Wear
D. Place the OFF-ON switch in the OFF position.
To disassemble the freezer, refer to the following steps:
A. Remove the mix inlet regulator from the hopper by
pulling straight up.
B. Remove the front door by turning off the circular
knobs and then pulling the front door off the studs
(Fig. 21).
Figure 21. Removing Front Door
C. Remove the rosette caps from the front door. Push
the spigot body through the bottom of the front door
and remove. (Fig. 22).
Figure 22. Front Door Disassembly
D. Remove the front auger supports and bushings
(Fig. 24).
D. Remove the clear acrylic splash gaurd from the
blender.
E. Remove the blender's agitator from the agitator shaft.
Grasp the agitator shaft in one hand, and turn the
agitator in a clockwise direction with the other hand
(Fig. 23).
Figure 24. Removing Auger Supports
Figure 23. Removing Agitator From Shaft