Filter
Top Products
Planning Information
Built-In Model 650G
Dimensions in parentheses are in
millimeters unless otherwise specified.
6
FRAMED PANELS
Framed door panel
1
/4" (6) thick or less
Framed door panel thicker than
1
/4" (6)
ADDING PANELS
In your plan for panels, be sure you are working with the
Sub-Zero panel design family called for in your design. If
you have chosen the stainless steel design, the unit will be
shipped complete with wrapped stainless steel doors and
handle hardware. You will not have to install front door
p
anels.
If you and your client have ordered a framed or overlay
design model, you will be adding panels to give the unit
the custom Sub-Zero look. Specifications on the following
pages provide installation considerations for framed and
overlay door panels.
Side panels can be used with the framed, overlay and
stainless steel design applications. Refer to specifications
on page 11.
FRAMED PANELS
If the thickness of the custom panels is less than
1
/4"
(6), they must be backed up with a sheet of shim material
to build the total thickness to
1
/4" (6). If the panel is thicker
than
1
/4" (6), an edge must be routed ar
ound the panel to
ensure a proper fit. Refer to the illustrations on this page.
IMPORTANT NOTE: Routing, recessing or optional
extended handles may be required on raised panels for
finger clearance under the handle. Refer to the full-scale
illustrations on pages 12–15.
IMPORTANT NOTE: The weight of each panel cannot
exceed 50 lbs (23 kg).
The traditional framed models come with an 11" (279)
louvered grille and elegant full-length handle. Optional
extended full-length handles that provide additional finger
clear
ance for raised panels are available through your
Sub-Zero dealer. To obtain local dealer information, visit
the Locator section of our website, subzero.com.
For framed door panel dimensions and dimensions for the
optional panel grille for the framed application, refer to
specifications on page 7.
To install framed panels, refer to the installation instruc-
tions shipped with each unit
. These instructions can also
be found on our website, subzero.com.
PANELS
1
/4" (6) THICK OR LESS
1
/4" (6) Panel
Trim reveal
1
/4" (6) min
PANELS THICKER THAN
1
/4" (6)
Trim reveal
1
/4" (6) min
Rout to
1
/4" (6)
thickness