Sub-Zero ICB427 Beverage Dispenser User Manual


 
34
INSTALLATION CHECKLIST
The importance of the installation of the
Sub-Zero Wine Storage unit cannot be
overemphasized. Proper installation is the
responsibility of the selling dealer or installer.
IMPORTANT NOTE:
To ensure a safe and
proper installation, the following checklist
should be completed by the installer to ensure
that no part of the installation has been over-
looked.
Any questions or problems regarding the
installation should be directed to your
Sub-Zero dealer. You may also check the
Contact & Support section of our website,
subzero.com.
MODEL ICB430 INSTALLATION INSTRUCTIONS
HINGE ADJUSTMENT
IMPORTANT NOTE:
The unit must be installed
and leveled before adjusting the door hinges.
Check to make sure the door is properly
adjusted. If not, adjust the top or bottom door
hinge by first removing and discarding the two
small shipping screws. Refer to illustration 13
below. Adjust the top hinge left to right and in
or out by loosening the three allen head
screws. Adjust the bottom hinge by loosening
the four allen head screws with a 3 mm allen
wrench. Refer to illustration 14. The door will
now be able to move left to right or in and out.
90-DEGREE
DOOR STOP
An optional 90-degree door stop kit for Model
ICB430 is available through your Sub-Zero
dealer.
COMPLETING THE INSTALLATION
IMPORTANT NOTE:
When you have
completed the installation of the Model ICB430
Wine Storage unit, refer to the following
Installation Checklist and Service Information.
Illus. 13 Illus. 14
MODEL
ICB430
OPTIONAL
COMPONENTS
Optional installa-
tion components
are available
through your
Sub-Zero dealer.
You can also visit
our website at
subzero.com.