Filter
Top Products
12
UNPACKING AND MOVING
Uncrate the unit, remove its wood base and
discard the shipping bolts that hold the wood
base to the bottom of the unit. Remove all
packing materials and tape.
IMPORTANT NOTE:
Do not discard the
kickplate/grille, anti-tip bracket and hardware.
These items will be needed for the installation.
Retract the front leveling legs to allow you to
move the unit more easily during installation.
You will extend the leveling legs when the unit
is in its final position to reduce the possibility
of the unit tipping forward.
Use an appliance dolly to move the Integrated
unit. Position the dolly at the side of the unit to
prevent damage to finished surfaces. Secure
the door and/or drawers so they do not open
while moving the unit.
ANTI-TIP BRACKET
INSTALLATION
An anti-tip bracket and hardware is provided
with the Integrated unit. The anti-tip bracket
must be installed on a solid base.
If you are installing the unit in a space deeper
than 610 mm, be sure to locate the anti-tip
bracket so that it engages the unit properly. It
is important that the anti-tip bracket is placed
610 mm from the front of the unit without
panels, to the the back of the anti-tip bracket.
Refer to illustrations 1 and 2 below and note
that for 686 mm wide units dimension A is 343
mm, and 457 mm for 914 mm wide units.
INTEGRATED INSTALLATION INSTRUCTIONS
To prevent the unit from tipping forward
and provide a stable installation, the unit
must be secured in place with the anti-tip
blocking bracket.
Before moving the Integrated unit into
position, protect any finished flooring
with appropriate materials.