Filter
Top Products
Built-In Refrigeration 25
subzero.com/specs
Dual Installation
FLUSH INSET PANEL OFFSETS
When installing two built-in models side by side in a flush
inset application, you must decrease the width of the dec-
orative flush inset panels by 13 mm. Adjustments to the
panel offsets will also need to be made. These adjust-
ments are needed to achieve a proper fit and to ensure the
panels do not collide when closing. Panel dimensions in
the chart below have been adjusted to reflect the
decrease in panel dimensions.
IMPORTANT NOTE: If a filler strip is not used, dual instal-
lations can only be accomplished using two units with
opposite hinges.
Illustrations A–F provide panel offsets and reveals for all
built-in models in a flush inset application. Refer to the
chart below for reference to the illustrations relating to
your specific model. All reveals are 13 mm unless other-
wise specified.
For additional information on model-specific panel reveals,
visit the specification library section of our website,
subzerotrade.com.
16
mm
8 mm
13
mm
FLUSH INSET PANEL
SPACER
BACKER
DOOR / DRAWER / GRILLE
TOP VIEW
CABINETRY
Illus. A Illus. B
DUAL
TRIM
6 mm
REVEAL
8 mm
3 mm
DOOR DOOR
TOP VIEW
13 mm
8
mm
3
mm
CABINETRY
GRILLE
SIDE VIEW
Illus. C Illus. D
13 mm
2
mm
8
mm
8
mm
4
mm
GRILLE
DOOR
SIDE VIEW
16 mm
4
mm
8
mm
8
mm
2
mm
DOOR
DRAWER
SIDE VIEW
Illus. E Illus. F
8
mm
2
mm
DOOR /
DRAWER
SIDE VIEW
Panel Offsets Illus.
OVER-AND-UNDER
Doors (hinge) /Drawer /Grille Sides A
Doors (handle) Sides B
Grille Top C
Grille Bottom / Door Top D
Door Bottom / Drawer Top E
Drawer Bottom F
Do not exceed flush inset panel dimensions, as this
could cause damage to panels and the Sub-Zero unit.