Summit FF-6 Refrigerator User Manual


 
Door swing reversal
(
Stainless steel models with towel bar handles do not have reversible doors.)
If you find the direction of opening the door on your appliance inconvenient, you can
change it. Holes on the opposite side have already been prepared at the factory
1. Remove the top hinge cover and hinge (on models with a tabletop, remove the
bottom hinge instead).
2. Next remove the door and remove the bottom hinge.
3. Then remove the kick plate, slide it over to the opposite side and secure in place.
4. Place the lower hinge on the opposite side of the unit and reattach the door,
5. Reattach the top hinge on the opposite side of the unit, it should be aligned with
the bottom hinge
6. Remove handle by unscrewing, place on the opposite side and secure in place.
7. Insert plugs into the holes where the door was initially attached.
8. Check to make sure the door seals properly.
(If it does not, use a hair dryer set on medium to expand the gasket.)
1. Upper hinge cover 4. Kick plate
2. Upper hinge 5. Handle
3. Lower hinge 6 Hole Plugs
9