Filter
Top Products
PLACING AND INSTALLATION
It is important to make sure the appliance is leveled evenly to prevent falling.
Two spacers attached to the appliance must be fitted onto the upper edge of
the condenser, thus preventing the appliance from being installed too close to
the wall. Spacers are manufactured for all-purpose functions depending on the
distance of the condenser from the wall. Therefore turn spacers correspondingly
and adjust them accordingly to the appliance.
Connection to Power Supply
Connect the appliance with the cable and plug to the power supply socket outlet
with a ground terminal (safety socket).
“DO NOT USE AN EXTENSION CORD.”
Required nominal voltage and frequency are indicated on the rating plate.
The connection to the power supply and grounding has to be made according to
current standards and regulations. The appliance resists temporary voltage
tolerance up to -15 to 10%.
Operation Control
The freezer is controlled with a thermostat knob located in the upper right
hand corner of your refrigerator.
Temperature Selection
Higher settings on the knob (towards 7) mean colder temperatures in
all compartments of the appliance. The temperature in the interior of the
appliance may even drop below 32°F. Use the higher thermostat setting
only when required or recommended. We recommend that you set your
thermostat in the middle for standard temperature.
Changing the thermostat will affect the temperature inside of the
appliance; therefore choose your temperature wisely.
When the thermostat is on the STOP (0) position the appliance does
not operate.
Temperature in the freezer also depends on how often you open the door.
Instructions for Use