Filter
Top Products
Felix Storch, Inc.
SUMMIT APPLIANCE DIV.
Page 6
APPLIANCE OPERATION
Base Grill (some models only)
To Remove and Replace the Base Grill:
1. Open the appliance door and remove the base grill by pulling down and out from the top.
2. Replace the base grill by putting the clips in the openings in the appliance panel. Push in until the base grill snaps into place.
An optional stainless steel grill is available for some models (Models beginning with FF6, FF7, CT66, CT67, SCR600, FS62,
AL6, AL7, ALF6 and SWC6G ). You can order at www.summitapplianceparts.com
Changing the light bulb (some models only)
NOTE: Not all appliance bulbs will fit your appliance. Be sure to replace the bulb with one of the same size, shape, base size
and wattage. You can purchase bulbs from www.summitapplianceparts.com
1. Unplug appliance or disconnect power.
2. Remove the light shield. Most models do not require tools.
3. Replace the light bulb with an appliance bulb of the same wattage.
4. Replace the light shield.
5. Plug in appliance or reconnect power.
Loss of Power
After the power is restored, unplug the appliance for 30 minutes, to allow the refrigeration system to equalize. During this time
keep the door closed whenever possible.
REMEMBER: A full appliance stays cold longer than a partially filled one.
Moving Care
1. Remove all containers.
2. Unplug the appliance.
3. Clean it thoroughly.
4. Tape the appliance shut and tape the electrical cord to the cabinet.
When you get to your new location, refer to the “Installation Instructions” and “Appliance Use” sections for informa-
tion on installation and setting the controls.
When transporting appliances, it is recommended that you transport it upright.
If it is necessary to lay it down, lay on its side—never the front or back—and be sure to
check for water in the pan on top of the compressor before moving.