Summit SW-23 Refrigerator User Manual


 
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly ventilated room. Allowed ambient
temperature depends on the model (class) of the appliance. It is located on the
rating plate of the appliance. Make sure the appliance is on a leveled floor that is
strong enough to support the appliance when it is fully loaded.
Class Ambient Temperature
SN (sub-normal) from + 56°F to + 90°F
N (normal) from + 62°F to + 90°F
ST (sub-tropical) from + 64°F to +100°F
T (tropical) from + 64°F to +120°F
The appliance may be exposed to lower or higher temperatures but only for
shorter period of time and the temperature should never be lower than 41°F.
Never place the appliance near heat emitting devices (e.g. cooker, radiator, water
heater or similar devices) and do not expose it to direct sunlight. The appliance
should be positioned 3cm from the electric or gas cooker. Behind the appliance
there should be at least 200 cm² wide and above the appliance at least 5 cm away
from the appliance in order to assure adequate ventilation of the condenser unit.
Placing the Self-Standing Appliance
It is important to make sure the appliance is leveled evenly to prevent
falling.
Do not place the appliance in direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
The appliance with the ventilation grid may be placed close to the
wall. The grid enables sufficient air circulation that is required for
adequate ventilation of the rear wall.
Connection to Power Supply
Connect the appliance with the cable and plug to the power supply socket outlet
with a ground terminal (safety socket).
“DO NOT USE AN EXTENSION CORD.”
Required nominal voltage and frequency are indicated on the rating plate.
The connection to the power supply and grounding has to be made according to
current standards and regulations. The appliance resists temporary voltage
tolerance up to -15 to 10%.
Instructions for Use