Filter
Top Products
Operation Control
The refrigerator can be adjusted from colder to warmer by turning the
Temperature Control knob. Colder temperature can be achieved by turning the
control knob clockwise towards the “max” position. Warmer Temperatures can be
reached by turning the control knob counterclockwise towards the “min” position.
Temperature Selection
Higher settings on the knob (max) mean colder temperatures in all
compartments of the appliance. The temperature in the interior of the
appliance may even drop below 35°F. Use the higher thermostat setting
only when required or recommended. We recommend that you set your
thermostat in the middle for standard temperature.
Changing the thermostat will affect the temperature inside of the
appliance; therefore choose your temperature wisely.
When the thermostat is on the OFF position the appliance does not
operate.
Temperature in the refrigerator also depends on how often you open the
door.
Changing the Direction of Opening the Door
If you find the direction of opening the door on your appliance inconvenient, you
can change it. Holes on the opposite side have already been prepared at the
factory.
Some screws are covered with caps. Remove the caps before undoing the
screws.
Take off the upper hinge cap and unscrew the upper and lower hinges.
Remove the kick plate and place it in its new position.
Unplug the holes covering the holes on the opposite side of the appliance
door.
Undo the fastener of the upper hinge and fix it to the opposite side of the
appliance.
Put the door on the upper hinge fastener.
Fix the upper hinge and cover it.
Unscrew the handle and replace it to the opposite side (not for handles
mounted horizontally).
Plug the remaining holes with decorative caps.
Check the gasket, it should not be creased and should seal well.
Instructions for Use