Sunbeam FP5900P Range User Manual


 
Using your Sunbeam Fryware
Before the first use: Wash, rinse and dry your
frypan and lid. Season the cooking surface by
applying a thin coat of cooking oil and rub in
with paper towelling.
1. Insert the control probe into the inlet on
the frypan.
2. Plug the cord into a 230-240V power
outlet and turn the power on.
3. Set the control probe dial to the desired
temperature setting. Refer to page 13 for
the temperature guide.
Note: The light on the control probe will
illuminate and will remain on until the
set temperature is reached. It will then
cycle on and off throughout cooking, as
the temperature is maintained by the
thermostat. On initial heating of the frypan,
it is recommended that the temperature be
allowed to cycle (the light cycling on and
off) several times. This will help the cooking
surface to adjust to a more accurate cooking
temperature.
Adjustable lid holder
(Models FP5500P, FP5610P, FP5900P)
This is a stepped catch on the side of the lid.
It allows the lid to rest above the frypan and
eliminates the need to find a spot on the
bench. When in position the lid also acts as a
spatter shield. The lid can rest on either side
of the handle, making it easy for left or right
handed use.
Using the pan tilt lever
(Models FP5500P, FP5610P, FP5900P, FP5910)
The pan tilt lever is positioned under the inlet
where the control probe is inserted.
To tilt the frypan, push the lever down. This
allows the fat and juices to drain from the
food for crisp, low fat cooking. It also makes it
easier to baste food and serve sauces or gravy.
FP5610P
14
FP5610P