2
Sunbeam’s Safety Precautions.
Sunbeam are very safety conscious when designing and
manufacturing consumer products, but it is essential
that the product user also exercise care when using an
electrical appliance. Listed below are precautions which
are essential for the safe use of an electrical appliance:
• Read carefully and save all the instructions provided
with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove by
grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.
• Do not use your appliance with an extension cord
unless this cord has been checked and tested by a
qualified technician or service person.
• Always use your appliance from a power outlet of
the voltage (A.C. only) marked on the underside of
the appliance.
• Close supervision is necessary when your appliance is
being used near children or infirm persons.
• Never leave an appliance unattended while in use.
• Young children should be supervised to ensure that
they do not play with the appliance.
• Do not use an appliance for any purpose other than
its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven. Do not
place on top of any other appliance.
• Do not let the power cord of an appliance hang over
the edge of a table or bench top or touch any hot
surface.
• For safety reasons and to avoid maintenance by
unskilled persons, some appliances are ‘sealed’ using
tamperproof screws. Such appliances should always
be returned to the nearest Sunbeam Appointed
Service Centre for adjustment or repair if required.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
dropped or damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre for examination,
repair or adjustment.
• For additional protection Sunbeam recommend the
use of a residual current device (RCD) with a tripping
current not exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse in water or any other liquid,
unless recommended.
• Use your frypan at least 200mm away from
walls and curtains.
• Do not immerse the Control Probe in water.
• If using a plastic spatula do not leave in cooking
vessel when hot.
• The frypan must only be used with the Control
Probe provided.
• Avoid using on metal surfaces e.g. sink, hotplate.
• Remove the Control Probe before cleaning the
frypan.
• After cleaning the frypan ensure that the
Control Probe Inlet area is completely dry
before using again.
• The knob on the glass lid may get hot during
use - oven mitts may be required.
SAFETY PRECAUTIONS FOR ALL ELECTRICAL APPLIANCES
SAFETY PRECAUTIONS FOR YOUR FRYPANS.
If you have any concerns regarding the performance and use of your appliance, please ring our Toll Free number
(Australia only) 1800 025 059. New Zealand - contact the Sunbeam Office in Auckland on 09 912 0747.
Ensure the above safety precautions are understood.