Filter
Top Products
4
Using your Sunbeam Kettle BBQ.
Before first use.
Remove any stickers from the hotplate. Wash
the hotplate and drip tray in warm soapy water
using a mild household detergent. Dry hotplate
and drip tray thoroughly.
To assemble the stand.
Place the base of the stand (legs) on a flat level
surface. Take the pole and with the slots to the
bottom, insert the metal tube into the hole in
the centre of the base and push down firmly.
Place the base of the Kettle BBQ onto the pole
and fit it into position. The base is correctly
positioned when the pole has slid in
approximately 10cm.
Place drip tray into base. For easy cleaning line
the drip tray with aluminium foil. This will
collect the fats and juices.
Position the hotplate over base and drip tray, as
shown in Figure 1.
For better non-stick performance, “season” the
cooking surface of the hotplate by applying a
thin coat of cooking oil and rubbing in with
paper towelling before each use.
WARNING: Charcoal or similar combustible
fuels must not be used with this appliance.
NOTE: Do not place any objects such as
saucepans or plates on the hotplate.
Using your Kettle BBQ.
1. Insert the Heat Control Probe fully into the
socket of the hotplate.
2. Plug the cord into a 230-240 volt power
outlet and turn the power on. An extension
cord that has been checked and tested by
your electricity supplier or a qualified
technician may be used with your Kettle
BBQ.
3. Set the control probe dial to the desired
heat setting.
Remove the lid from the Kettle BBQ and
allow to heat up. When the thermostat light
on the control probe switches off, the
desired cooking temperature has been
reached and the Kettle BBQ is ready to use.
For oven style cooking, set the dial to Super
Sear setting, replace the lid and pre-heat for
approximately 10 minutes.
Note: The thermostat light on the control probe
indicates the Kettle BBQ is heating. This light
will remain ON until the set temperature has
been reached and then will cycle ON and OFF
throughout cooking. This will ensure that the
Kettle BBQ always maintains the selected
temperature. The pre-heat time will depend on
the heat setting selected.