Filter
Top Products
6
Care and Cleaning.
IMPORTANT: Do not use metal utensils on the
hot plate as these will scratch the non-stick
cooking surface.
Do not leave plastic utensils in contact with
hotplate while cooking.
Before cleaning, turn the power OFF then
REMOVE the plug from the power outlet and
the Heat Control Probe from the socket of the
Kettle BBQ.
Heat Control Probe.
If cleaning is necessary, wipe over with a damp
cloth.
Do not immerse the control probe in water or
any other liquid.
NEVER use the Kettle BBQ control probe in any
other appliance.
Storage
Store the probe carefully in a safe place. Do not
knock or drop it as this can damage the probe. If
damage is suspected, return the control probe
to your nearest Sunbeam Service Centre for
inspection. Refer to the back of your instruction
book for Service Centre listings.
Hotplate and Drip Tray.
The element in the hotplate is totally sealed, so
it is safe to fully immerse in water. Wash the
hotplate and drip tray in warm soapy water
using a mild household detergent and a soft
washing sponge.
A bottle brush may be used to clean the
drainage holes in the ribbed hotplate.
The hotplate and drip tray are also
dishwasher safe.
Do not use abrasives or metal scourers as they
will scratch the non-stick cooking surface. Dry
the hot plate and drip tray thoroughly before
storing.
Moulded Base and Lid.
The base and lid can be wiped over with a damp
cloth or washed in warm soapy water using a
mild household detergent and a soft washing
sponge.
Do not place the moulded base or lid in a
dishwasher.
Do not use abrasives or metal scourers as they
may scratch these parts.
Stand
The stand can be wiped over with a damp cloth.
Do not place any part of the stand in a
dishwasher.
Storage.
Always dry and assemble the Kettle BBQ before
storing. Ensure the drip tray and hotplate are
correctly positioned.
For outdoor storage of your Kettle BBQ, remove
the control prove and store in a safe, dry place.
Important:
Before inserting control probe in probe socket
ensure the interior of the socket is fully dry. To
do this wipe interior of socket with a dry cloth
or shake out excess water vigorously.
Sunbeam is a Registered trademark. Made in China. Due to
minor changes in design or otherwise, the product you buy
may differ from the one shown in this booklet. Approved by
the appropriate Electrical Supply Authorities. Backed by
Sunbeam’s 12 Month Replacement Guarantee and National
Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2001.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.