Filter
Top Products
4
Using your Sunbeam Kettle King.
Before first use.
Remove any stickers from the hotplate. Wash
the hotplate and drip tray in warm soapy water
using a mild household detergent. Dry hotplate
and drip tray thoroughly.
To assemble the stand. (HG6600 only)
Place the base of the stand on a flat level
surface. With the slots to the bottom, insert the
metal tube into the hole in the centre of the
base and push down firmly.
Place the swivel shelf over the metal tube with
the handle on your left. Slide the shelf down the
metal tube until it rests on the two plastic pins
as indicated in Figure 1. Never attempt to
remove the plastic pins from the metal tube, as
these are the locators for the swivel shelf.
Place the top shelf onto the metal tube with the
utensil rack facing away from you and align it
with the swivel shelf. Push down firmly in the
centre of the top shelf to secure it.
Place the base of the Kettle King on the top
shelf and fit it into position. The base is correctly
positioned when it is flush with the top shelf of
the stand on all sides.
Place drip tray into base. For easy cleaning line
the drip tray with aluminium foil. This will
collect the fats and juices.
Position the hotplate over base and drip tray, as
shown in Figure 1.
For better non-stick performance, “season” the
cooking surface of the hotplate by applying a
thin coat of cooking oil and rubbing in with
paper towelling before each use.
WARNING: Charcoal or similar combustible
fuels must not be used with this appliance.
NOTE: Do not place any objects such as
saucepans or plates on the hotplate.
Using your Kettle King.
1. Insert the Control Probe fully into the socket
of the hotplate.
2. Plug the cord into a 230/240V power outlet
and turn the power on. An extension cord
that has been checked and tested by your
electricity supplier or a qualified technician
may be used with your Kettle King.
3. Set the control probe dial to the desired
heat setting.
Remove the lid from the Kettle King and
allow to heat up. When the thermostat light
on the control probe switches off, the
desired cooking temperature has been
reached and the Kettle King is ready to use.
For oven style cooking, set the dial to Roast
setting, replace the lid and pre-heat for
approximately 10 minutes.
Note: The thermostat light on the control probe
indicates the Kettle King is heating. This light
will remain ON until the set temperature has
been reached and then will cycle ON and OFF
throughout cooking. This will ensure that the
Kettle King always maintains the selected
temperature. The pre-heat time will depend on
the heat setting selected.