Filter
Top Products
Using your Aroma Coffee
™
12
Before first use
Before brewing coffee in your new coffee
maker, clean thoroughly as follows;
1.With warm soapy water clean the carafe
and removable filter basket. Rinse with
clean water and dry.
2.Open the hinged top lid and fill the
water reservoir with cold tap water to the
maximum level marked on the water level
gauge.
3.Place the glass carafe into position on the
warming plate of the coffee maker.
4.Plug the coffee maker into a 230-240 volt
AC power outlet and switch power on.
5.Press the power switch ‘ON’ to commence
the brewing cycle, without ground coffee or
the mesh filter.
6.At the end of the first cycle turn the coffee
maker off and wait ten minutes. Remove
the carafe and empty out water.
7.Replace the carafe, refill the water reservoir
and commence the brewing cycle without
ground coffee or mesh filter.
Your Aroma Coffee™ 12 is now ready for use.
Brewing coffee
1.Place your coffee maker on a flat, level
surface.
2.Open the hinged top lid and fill the water
reservoir with cold tap water up to the
maximum level marked on the water level
gauge for the desired amount of coffee.
Note: A minimum of two cups is required.
Note: Do not use the carafe to fill the unit
with water as it may contaminate the insides
of your coffee maker with coffee residue.
3.Insert the permanent mesh filter into the
filter holder.
4.Spoon the desired amount of ground coffee
into the filter.
Note: We recommend that you allow one
tablespoon of ground coffee for each cup of
brewed coffee. However you may vary the
quantity according to your taste.
Note: If you place too much ground coffee
into the filter, coffee grinds may overflow
during the brewing process and be deposited
in the carafe.
5.Close the hinged top lid so it clicks shut.
6.Place the empty glass carafe into position
on the warming plate.
7.Plug the coffee maker into a 230-240 volt
AC power outlet and switch power on.
8.Press the power switch ‘On’.
Aroma Coffee 12 (PC3600 and PC3610);
once the coffee maker is switched on, the
power switch will illuminate.
Aroma Coffee 12 Digital (PC4700); once
the coffee maker is switched on, the small
power light next to the power button will
illuminate. See ‘How to use the Electronic
Programming’ section for further details on
programming the automatic brew feature.
9.When the brewing cycle is completed the
warming plate will keep the coffee hot as
long as the coffee maker is switched on.
Note: There is no need to wait between
brewing cycles. As soon as you have brewed
one pot of coffee, you may immediately brew
another carafe.
10. Switch the coffee maker ‘Off’ after use
and unplug from the power outlet.
4