Filter
Top Products
After each use
1. Turn the power off and remove the plug
from the power outlet.
2. Allow the iron to cool before winding
the cord around the built-in cord wrap.
Storage
Always store the iron on its heel rest.
Do not store the iron with the soleplate
facing down, or in the carton.
Cleaning
To clean the exterior of your iron, wipe
over with a damp soft cloth and wipe dry.
Caution: Do not use harsh abrasives,
chemical cleaners or solvents to clean the
exterior of your iron as these will damage the
surface.
Cleaning the steam holes
To remove build up from the steam holes
which may affect steam performance,
use a cotton wool tip moistened in
methylated spirits.
Cleaning the Resilium
®
soleplate
Wipe with a soft damp cloth and wipe dry.
Caution: Do not use scouring pads, abrasives
or harsh cleaners to clean your Resilium
®
,
soleplate, as these will scratch and damage
the surface.
8
Care and Cleaning
Troubleshooting
If the following conditions occur
simultaneously, it indicates a possible fault
within the thermistor. These conditions
will persist until the soleplate thermistor is
working correctly.
• The temperature alert light flashes red
continuously, and
• The LCD backlight remains lit, and
• The temperature cannot be changed from
the MAX setting, and the circular graphic
flashes and counts up to the MAX segment
continuously.
To reset the iron, simply switch it off at
the power outlet, switch it back on again
and wait 15 seconds. The iron should now
operate normally. If the fault occurs regularly
return the iron, along with your purchase
receipt, to the place of purchase for a
replacement or refund.
Note: the fault conditions described above
are different to what occurs when the safety
auto-off feature is activated. When the iron
is in the auto-off mode the LCD backlight
will flash, the temperature alert light on the
handle will flash red, and a warning beep
will sound.