Sunbeam WF6000 Water Dispenser User Manual


 
Using your Water Filter
& Chiller
Before using your Water Filter
& Chiller
• Carefully unpack the appliance and check
that all the components are included.
• Remove the filter cartridge and keep in a
safe place.
• Remove the lid and filtering tank and wash
in warm soapy water, rinse and wipe dry.
Do not re-insert until (a) flushing process
and (b) preparation of filter cartridge
procedures, as explained below, have been
completed.
• Wipe out the filtered water tank with a
damp cloth which has been soaked in
water.
• Position the appliance on a dry, level and
secure bench top. Allow a good airflow
around the appliance so do not place
directly against a wall.
• It is important that you flush and rinse out
the dispensing system before using the
appliance for the first time.
• Fill the water tank to the brim with hot tap
water.
• Place a large container or jug under the
spout.
• Press the dispenser lever until all the water
is dispensed and the water tank is empty.
• Repeat this flushing process twice with cold
tap water and discard.
• Please note that when flushing for the first
time, while pressing the dispensing lever,
no water will be dispensed until the tank is
almost empty as it will be filling the chilling
tank.
• Do not fill above the maximum level
indicated.
• Please note that you should carry out these
steps without the Maxtra cartridge in place.
• Plug the appliance into an appropriate
electrical outlet and switch on.
• A white power on light will be illuminated to
show that the appliance is switched on and
working.
6