Sunbeam WF6000 Water Dispenser User Manual


 
Using your Water Filter & Chiller (continued)
Preparing the BRITA
®
MAXTRA filter
cartridge for use
• Remove the cartridge from its wrapping (it is
normal for the cartridge to appear moist).
• Immerse the cartridge in cold water and
agitate gently to remove any air bubbles
(see figure 1).
• Insert the cartridge into the 2 litre filtering
tank and push it firmly into place until
it ‘clicks’.
• Place the filtering tank into the sink. Fill the
filtering tank from the tap with cold water,
and allow the water to pass through the
filter in to the sink until empty. This is to
flush through any dry carbon dust.
• Then insert the filtering tank into the water
tank. Now refill with cold tap water, and the
system is ready for use.
Note: Repeat the cartridge preparation
process each time you insert a new cartridge.
• Once the water has been filtered, you can
refill this section.
• This will then filter through as water is
dispensed.
• After approximately 4 hours, the power light
will change from white to blue to indicate
that the water has been chilled.
• The light may flicker from blue to white
as water is dispensed and if the ambient
temperature increases. The fan may be
activated in these conditions and will remain
so until the required temperature has been
reached.
Figure 1
7