Filter
Top Products
930482 Rev. A
IX. Set-Up, Adjustment & Use
29
D. JOYSTICK SWING-AWAY RETRACTABLE MOUNT
(OPTIONAL)
The joystick is mounted with a mechanism which
allows the control to be locked in a forward or retract-
ed position using magnets.
Adjustment
a. To retract joystick, push outward on the inside of
joystick.
b. Push joystick away from front of armrest until it
locks into retracted position.
c. To return to forward position, push joystick
forward until it locks into place.
E. JOYSTICK
The Quickie V-100 is standard with an integral
controller/joystick.
F. HEIGHT-ADJUSTABLE ARMRESTS (OPTIONAL)
1. Installation
a. Slide the outer armpost into the receiver mount-
ed to the wheelchair frame.
b. The armrest will automatically lock into place.
2. Height Adjustment
a. Rotate release lever to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad until upper armpost locks firmly
into place.
3. Removing Armrest
a. Rotate release lever to first stop and remove the
armrest.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever to locked position
against armpost.
IX. Set-Up, Adjustment & Use
930482 Rev. A
28
A. BATTERY REMOVAL
To remove the batteries for transporting
or servicing:
1. Remove Batteries
a. Unplug batteries from controller.
b. Unfasten the battery hold-down straps (A).
c. Remove batteries from rear of chair.
d. Lift up batteries by lifting up on
battery straps (B).
Batteries may weigh up to 40 lbs. Care must be
taken to avoid injury when lifting.
B. SWING-AWAY FOOTRESTS
1. Installation
a. Place swing-away pivot pin into the locating
hole (C) on top of the hanger mount with the
footrest facing outward from frame.
b. Rotate the footrest inward until latch plate locks
(D) into place on locking bolt.
2. Removal
a. To remove footrest, press quick-release lever (E).
b. Rotate footrest outward and lift.
3. Height Adjustment
a. Remove both bolts (F) in the hanger frame tube.
b. Reposition footrest height.
c. Re-tighten all bolts (F).
C. ARTICULATING LEGREST OR ELEVATING LEGREST
(optional)
1. Installation
To install or remove articulating legrest (ALR) or
elevating legrest (ELR) see instructions for
swing-away hangers and footrests.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest
will automatically lock in place.
b. To lower, while seated in chair, press release
lever forward and lower legrest to desired posi-
tion. Legrest will automatically lock in place.
A
B
Integral Joystick
F
Articulating
Legrest
Elevating
Legrest
D
C
E