Taylor 168 Freezer User Manual


 
14
Models 150, 152, 162, 168Operating Procedures
060421
Assembly
Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
Step 1
Install the beater assembly. Slide the small, thick o-ring
into the groove on the drive shaft of the beater
assembly. Apply an even coat of Taylor Lube to the
o-ring and the shaft.
DO NOT LUBRICATE THE HEX END.
Figure 7
Insert the beater assembly through the rear shell
bearing at the back of the freezing cylinder and engage
the hex end firmly into the female socket. When
properly seated, the beater will not protrude beyond
the front of the freezing cylinder.
Figure 8
Repeat this step for the second freezing cylinder on
Models 162/168.
Step 2
Assemble the freezer door. Place the large o-ring(s)
into the groove(s) on the back of the freezer door and
lubricate with Taylor Lube.
Figure 9
Slide the front bearing(s) over the baffle rod(s) so the
flanged edge is against the door . Place the white
plastic guide bearing(s) on the end of the baf fle rod(s).
DO NOT LUBRICATE T HE FRONT BEARING(S) OR
THE GUIDE BEARING(S).
Figure 10
Step 3
Slide the slotted portion of the handscrews into the
slots in the freezer door.