Taylor 168 Freezer User Manual


 
15
Models 150, 152, 162, 168 Operating Procedures
Step 4
Install the freezer door. With both hands, hold the sides
of the freezer door and insert the baffle rod(s) into the
center of the beater assembly(ies). The white guide
bearing(s) must fit securely in the hole(s) of the drive
shaft(s). Finger-tighten the handscrews equally to
insure that the door is snug. Do not over-tighten.
Note: The freezer door is in the correct position when
the door spout is on the bottom.
Step 5
Install the draw valve(s). S lide the two o-rings into the
grooves on the draw valve(s) and lubricate with Taylor
Lube.