Filter
Top Products
3Models 380/381 Safety
050906
Section 3 Safety
We at Taylor Company are concernedabout the safety ofthe
operator when he or she comes in contact with the freezer
anditsparts.Taylorhas gonetoextreme effortstodesignand
manufacture built-in safety features to protect both you and
the s ervice technician. As an example, warning labels have
been attached to the freezer to further point out safety
precautions to the operator.
IMPORT ANT -- Failure to adhere to the following
safety precautions may result in severe personal injury.
Failure to comply with these warnings may damage the
machine and its components. Component damage will
result in part replacement expense and service repair
expense.
To Operate Safely:
DO NOT operate the freezer without reading this
operator’s manual.Failuretofollow thisinstruction mayresult
in equipment damage, poor freezer performance, health
hazards, or personal injury.
S DO NOT operate the freezer unless it is properly
grounded.
S DO NOT attempt any repairs unless the main
power supply to the freezer has been
disconnected.
S DO NOT operate the freezer with larger fuses
than specified on the freezer data label.
Failuretofollow theseinstructionsmay resultin electrocution
or damage to the machine. Contact your local authorized
Taylor Distributor for s ervice.
DONOT use a waterjet toclean orrinse thefreezer.
Failure to follow this instruction may result in serious
electrical shock.
S DO NOT allow untrained personnel to operate
this machine.
S DO NOT operate the freezer unless all service
panels and access doors are restrained with
screws.
S DO NOT remove the door, beater, scraper blades,
or drive shaft unless the power switch is in the
“OFF” position.
S DO NOT put objects or fingers in the door spout.
Failure to follow these instructions may result in
contaminated product or severe personal injury to fingers or
hands from hazardous moving parts.
USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very sharp and
may cause injury.
These freezers must be placed on a level surface.
Failure to comply may result in personal injury or equipment
damage.
DO NOT obstruct air intake and discharge openings: 6”
(152 mm) minimum air space on front, sides and rear of the
unit. Failure to follow this instruction may cause poor freezer
performance and damage to the machine.
These freezers are designed to operate indoors, under
normalambienttemperatures of70_-- 7 5 _F(21_-- 2 4 _C). The
freezers have successfully performed in high ambient
temperatures of 104_F(40_C) at reduced capacities.
NOISELEVEL:Airborne noiseemissiondoes notexceed 78
dB(A) when measured at a distance of 1.0 meter from the
surface of the machine and at a heightof 1.6 meters fromthe
floor.