Filter
Top Products
31
Models 8752 & 8756 with Horizon® Pump Operating Procedures
Draining Product From the
Freezing Cylinder
Step 1
Press the AUTO and MIX REF keys to cancel freezer
operation.
Step 2
Open the mix cabinet door and remove the mix storage
cover(s), mix tank cover(s), mix tank(s), and mix
probe(s). Empty t he mix f rom the mix tank(s) into a
sanitized stainless steel rerun c an.
Step 3
Place the suction line in an empty pail in the mix
cabinet.
Step 4
If local health codes permit the use of rerun,place
a sanitized, NSF approved stainless steel rerun
container beneath the door spout.
S Open the d raw valve and press the WASH
and PUMP keys.
S Drain all the m ix from the freezing cylinder.
S When all the product stops flowing from the
door spout, close the draw valve and press
the WASH and PUMP keys to stop
operation.
S Place a sanitized lid on the rerun c ontainer
and place it in the walk--in cooler.
Note: If local health codes DO NOTpermit the use
of rerun, the product must bediscarded. Follow the
instructions in the previous step, except drain the
product into a mix pail and properly discard the mix.
Repeat Steps 3 through 4 for t he second freezing
cylinder on the Model 8756.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Rinsing
Step 1
Fill the empty pail in the mix cabinet with 2 gallons (7.6
liters) of cool, clean water. Place the free end of the
suction line in the pail of water.
Step 2
Disconnect the pressure line from the check valve and
place it in the pail of w ater.
Figure 59
Step 3
Press the PUMP key. This action will cause the rinse
water to be pumped through the H orizon® pump and
out through the pressure line. After approximately 15
seconds, press the PUMP key to stop operation.
Step 4
Drain and connect the free end of the pressure line to
the check valve.
Figure 60