Filter
Top Products
1
Models BC10/BW11 To the Installer
040406
Section 1 To the Installer
This machine is designed for indoor use only.
DO NOT install the machine in an area where
a water jet could be used to clean or rinse the machine.
Failure to follow this instruction may result in serious
electrical shock.
Electrical Connections
Each unit requires one power supply. Check the data
labels on the unit for fuse, wire ampacity and electrical
specifications. Refer to the wiring diagram for proper
power connections.
In the United States, this equipment is intended to be
installed in accordance with the National Electrical
Code (NEC), ANSI/NFPA 70--1987. The purpose of
the NEC code is the practical safeguarding of persons
and property from hazards arising from the use of
electricity. This code contains provisions considered
necessary f or safety. Compliance therewith and
proper maintenance will result in an installation
essentially free from hazard!
In all other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local authorities.
Stationary appliances which are not equipped with a
power cord and a plug or other device to disconnect
the appliance from the power source must have an
all--pole disconnecting device with a c ontact gap of at
least 3 m m ins talled in the external installation.
CAUTION: THIS EQUIPMENT MUST BE
PROPERLY GROUNDED! FAILURE TO DO SO
CAN RESULT IN SEVERE PERSONAL INJURY
FROM ELECTRICAL SHOCK!
Foot Pedal Instructions
To use the momentary foot pedal to control the mixer,
connect the foot pedal to a grounded wall outlet. Plug
the mixer cord into the back o f the foot pedal plug. In
this mode, both the control switch and the foot pedal
must be activated. Leave the control switch in the “ON”
position when you wish to u se the momentary foot
control. Make sure the foot control is k ept where it will
not be activated accidently. The foot guard is an
additional design feature which helps prevent
accidental use of the foot pedal.