Filter
Top Products
Unlocking to cook
To unlock the control and use the applian-
ce, follow these steps:
1 Touch the Power sensor button (6)
and the sensor button of the front right
heating element (3) at the same time.
The L will disappear from the indicators
and a 0 with a flashing decimal point (11)
will appear, or an H will appear if the
corresponding heating element is hot, and
the hob will be ready to be used for coo-
king. When the control panel is disconnec-
ted using the on/off sensor button
(1), the safety function will reactive and will
appear again the next time the touch con-
trol panel is activated.
Cancelling the safety function
The safety function can be deactivated
permanently by following these steps:
1 Touch the Power sensor button (6)
and the sensor button of the front right
heating element (3) at the same time.
2 Immediately afterward, touch the Power
sensor button (6).
For the operation to be carried out, no
other sensor button should be touched in
the following 10 seconds. If the operation
is not carried out correctly, the touch con-
trol panel will remain locked and will turn
off after 20 seconds.
When the on/off sensor (1), is used
to reactivate the control panel after cance-
lling the safety function, the hob will be
ready to be used for cooking.
Stop Function
(models IRX... and IQX...)
By using this function, it is possible to
make a pause during the cooking process.
If the timer function is also activated, it will
also be paused.
Activating the Stop function
1 The cookware is located on the cooking
zones, which are working at a certain
level.
2 Touch the Stop sensor button (7) for
one second. The function will be pau-
sed.
The symbol will appear in the indicators
of the heating elements, and the error
messages, residual heat, fast heat-up or
lack of cookware indicators, will also
disappear until the function has been
deactivated.
Deactivating the Stop function
1 Touch the Stop sensor button (7)
and then touch any other sensor button
within 10 seconds.
The heating element will go back to how it
was before the Stop function was activated.
The second sensor button must be tou-
ched within 10 seconds; otherwise, the
hob will disconnect. If cooking has not
been restarted 10 minutes after the pause,
the appliance will turn off.
Double or Triple Circuit
hotplates (models TRX...)
Double and triple circuit heating elements
make it possible to use the inner ring or,
also, the outer ring(s), depending on the
GB
22