Filter
Top Products
Indicator symbol of the clock sensors
zone.
Indicator of selected time (clock).
Indicator light of the induction element
with timer.
Indicator symbol of the induction ele-
ment with timer.
Keep Warm Function sensor button
(models IRX... and IQX...).
Decimal point in power indicators.
- Shines (on): Chosen induction element
(ready to be used).
- Doesn't shine (off): Induction element
locked (cannot be used).
NOTE: * Only visible when appliance is
operating.
Actions are carried out using the sensor
buttons marked on the control panel.
It is not necessary put pressure on the
glass; by simply touching the sensor but-
ton with your finger you will activate the
desired function.
The touch cursor can be used to adjust the
power levels (1-9) and to choose the time
(1-99) by sliding your finger over it. By sli-
ding your finger to the right, the value will
increase, while sliding it to the left will
cause the value to decrease.
It is also possible to directly select the des-
ired value by touching the area of the
touch cursor with your finger.
Each action is confirmed with a beep.
TURNING ON THE APPLIANCE
1 Touch the on sensor button (1) for
at least one second.
The touch control panel is activated and a
0 appears on all the power indicators (3).
The decimal point (16) flashes to indicate
that no cooking zone has been selected at
that time. If a cooking zone is hot, the
corresponding indicator will show an H and
a 0 alternately.
In IRX... and IQX... models, if the Lock
Function is activated, the indicators in the
cooking zones will have an L. If there is a
residual heat on the cooking zones, the
corresponding indicator will have an L and
an H alternately.
The next action must be taken within 20
seconds; otherwise, the touch control
panel will automatically turn off. If you
have chosen a heating element at a power
level of 0 and you don't change the value,
the heating element will no longer be
selected after 10 seconds.
When the touch control panel is activated,
it can be disconnected at any time by tou-
ching sensor (1), even if it has been
locked (see the section "Locking the sen-
sor buttons of the hob"). Sensor button
(1) is always able to disconnect the
touch control panel.
ACTIVATING THE HEATING ELEMENTS
Once the touch control panel has been
activated by using sensor button (1),
you can turn on the chosen heating ele-
ments.
1 Choose the heating element by using the
corresponding indicator (3), i.e. by using
your finger to touch the digit. If the hea-
ting element is hot, the corresponding
indicator will go from showing H to level
0.
2 Use the slider cursor to choose the
power level, from between 0 and 9. By
doing so, the heating element will
remain activated.
GB
20
15
16
11
12
13
14