Filter
Top Products
induction element on the same side may
use the remaining power, up to a total of
3,600 watts. If its power level is too high,
the touch control panel will automatically
decrease it.
Afterward, the induction element will conti-
nue operating at power level 9. The func-
tion may also disconnect automatically if
the cooking zone temperature is very high.
If the cookware is taken off of the cooking
zone while the Power concentration func-
tion is activated, the function will remain
active and the time will continue to pass.
The Power function can also be activated
without placing cookware on the cooking
zone, but the cooking element will not
supply energy until cookware has been
placed on the cooking zone.
Safety disconnection
MAXIMUM OPERATION TIME
If one or various heating elements are
accidentally left on, they will be disconnec-
ted automatically after a certain amount of
time has passed after the last action using
the element. (See table 2)
When the "safety disconnection" has occu-
rred, the residual heat indicator H of the
corresponding heating element will appear
in the power indicator if there is a risk of
burn. Otherwise, a 0 will be shown.
SAFETY IN CASE OF COVERED SEN-
SOR BUTTONS
The touch control panel has a function that
makes it so the appliance automatically
detects when there is an object (cookware,
rag or spilled liquids) covering the panel
sensor buttons. This makes it possible to
prevent the object from activating or deac-
tivating a heating element without you rea-
lising it.
When the touch control panel disconnects
the appliance for safety reasons, it begins
to beep and it shows an error message
until the object covering the control panel
is removed.
If the touch control panel is in stand-by
mode, it will not detect the presence of an
object on it; nonetheless, to be able to acti-
vate the control panel, it is necessary to
remove the object on the control panel
beforehand.
Timer function
This feature enables you to do your coo-
king while you yourself are not present: the
timed heating element will turn off automa-
tically when the time you have chosen
elapses.
Around the indicator of the chosen time
there are four or three indicator lights (13)
that indicate which of the heating elements
is timed. For example, if you time the
upper left heating element, the light over
the indicator will turn on, on the left.
If the timer is not being used with any of
GB
Table 2
0
6
6
5
5
4
1,5
1,5
1,5
1,5
10 minutes, readjusts to 9
0
1
2
3
4
5
6
7
8
9
P
Power level
selected
MAXIMUM
OPERATION TIME
(in hours)