Filter
Top Products
The hose should hang freely with no bends, folds, or kinks that could obstruct
free flow of gas. Apart from the connection point, no part of the hose should
touch any hot grill parts. Always inspect the hose for use with LPG and meet the
national standards for the country of use.
FIXING THE REGULATOR TO THE GAS BOTTLE:
Confirm all grill control knobs are in the off position. Connect the regulator to the
gas bottle according to your regulator and bottle dealer’s instructions.
Leak testing
Confirm that you are in a well-ventilated area and that all grill control knobs are in
the off position. Open the gas control valve on the bottle or regulator. Check for
leaks by brushing a solution of
water and soap over all gas system joints,
including all valve connections, hose connections, and regulator connections.
NEVER USE AN OPEN FLAME to test for leaks at anytime. If bubbles form over
any of the joints, there is a leak. Turn off the gas supply and retighten all joints.
Repeat test. If bubbles form again, do not use the grill and contact customer
service. Leak test annually, and whenever the gas bottle is removed or replaced.
Always remember that before use, take care to ensure that no bubbles have
formed over any of the joints.
OPERATION
WARNINGS:
• Before proceeding, make certain that you understand the IMPORTANT
INFORMATION section of this manual.
Preparation before cooking:
To prevent foods from sticking to the cooking grill, please use a long handled
brush to apply a light coat of cooking or vegetable oil before each grilling session.
(Note: when cooking for the first time, paint colors may change slightly as a
result. This is normal and should be expected.)
Lighting the grill:
1. In order for the igniter switch to work, please make sure the battery is
properly installed.
2. Ensure all knobs are in the “OFF” position. Open the gas control valve on
the gas bottle or regulator.
3. Open the gas control valve at the cylinder.
4. From “OFF” position, push down the front left control knob and keep
pressing while turning counter clockwise to the “HIGH” position and
pressing the ignition button (you will hear a clicking sound), this will light
the left hand burner.
5. If burner fails to light, turn to “OFF” position and wait five minutes. Then
begin again with step 3.
6