Filter
Top Products
If burner still fails to light after several attempts, try the manual ignition
procedure below.
6. When the left hand burner is lit the remaining burner can be lit by
repeating steps 3 and 4.
7. To preheat the griddle, place the knob on “HIGH” position for 3-5 minutes.
8. After use, turn all control knobs to the “OFF” position and turn off the gas
control valve at the cylinder.
1. Take out removable grease drip tray.
2. Open the gas control valve at the cylinder.
3. Insert lit match through the space vacated by grease drip tray on the left
side of the burner.
4. Push and turn the knob closest to the piazzo lighter counter clockwise to
the “HIGH” position and light with match.
5. If the burner fails to light after 5 seconds, turn to “OFF” position and wait 5
minutes. Then begin again from step 2. If the burner fails to light after
several attempts, go to step 6, and call customer service.
6. After successfully lighting the first burner, turn next control knob to the
“HIGH” position. The gas will ignite from lit burner on the left. Follow the
same procedure for each successive burner. Light the remaining burners
from left to right.
7. After use, turn all control knobs to the “OFF” position and turn off the gas
control valve at the cylinder. NOTE: If the flame of the burner has a
yellow hue, adjust the aeration screw located on the neck of the burner.
The burner flame should be blue. Blue hued flames are confirmation that
the burner is burning properly. Turning the screw counter clockwise will
increase the amount of blue and clockwise will increase the amount of
yellow.
End of cooking session:
Do not allow your grill to overheat. After each cooking session, turn the grill
burners to the “HIGH” position and burn for 5 minutes. This procedure will
burn off cooking residue, thus making cleaning easier.
Turning off your grill:
When you have finished using your grill, turn all of the control valves fully
clockwise to the “OFF” position, then turn off the gas at the bottle. Wait until
the grill is sufficiently cool before storing.
7
MANUAL IGNITION PROCEDURE: