Filter
Top Products
Built-in Oven Care and Use Manual
Do-It-Yourself Maintenance
Do-It-Yourself Maintenance
Replacing the Oven Light
Replace bulb with a 12-Volt, 10-Watt Halogen bulb
only.
To replace Halogen Bulb:
1. Turn off circuit breaker.
2. Remove oven racks.
3. Slide the tip of a table knife blade between the
fixing clip and the glass lens cover.
4. Support the glass lens cover with two fingers
along the bottom edge to prevent the cover from
falling to the bottom of the oven.
5 Gently twist the knife blade to loosen the glass
lens cover.
6. Remove the glass lens cover and fixing clip.
7 Remove the bulb by grasping and sliding the bulb
straight up until the two prongs have cleared the
ceramic holder.
8. Do not touch the glass of the new replacement
bulb with your fingers. It will cause the bulb to
fail when it first lights. Grasp the replacement
bulb with a clean paper towel or facial tissue with
the prongs facing down. Locate the two prongs
in the ceramic holder, gently poking until the two
prongs locate in the ceramic socket.
9. Press down to seat the bulb.
CAUTIONS:
To prevent personal injury:
• Before replacing the light bulb, be sure the
electric power is turned off at the circuit
breaker.
• Halogen bulbs get HOT instantly when
turned ON.
• Be sure the oven and light bulb are cool.
• Do not operate the oven unless the light
cover is securely in position.
CAUTION: If the light cover is damaged or
broken, do not use the oven until a new cover is in
place.
The oven lights are located on the top ceiling wall
of the oven. The lights have a removable lens cover
and a halogen light bulb. The ceramic light socket
housing is not removable by the user.
31
10W HALOGEN
LAMP
Fixing
Clip
Housing
Ceramic Holder
Holder Clip
Lens
The oven has been preset to a 12- hour clock format.
To change the Time-of-Day Clock to a 24-Hour
Clock, follow these steps:
1. Turn off both ovens.
2. Touch START and hold the CLOCK pad at the
same time.
3. 12H appears in the Clock window; release both
pads.
4. Touch CLOCK and 24H replaces 12H. This al-
ternates when CLOCK is touched.
5. To complete the change, touch START.
Changing to the 24-Hour Clock Format
10. Place the fixing clip on the lens cover.
11. Slide the protective lens into the holder clip and
push the other end until the fixing clip snaps back
into the housing.
12. Turn on circuit breaker.