Filter
Top Products
www.thermador.comThermador Dishwasher Model DW44Z
Rinse Agent
Rinse agent or a rinse aid is used to provide optimum
drying results and diminish water spotting. Always
use a rinse agent with the Thermador dishwasher to
insure proper drying results. It rinses the dishware and
also rinses the internal parts of the dishwasher.
Rinse Agent Indicator Light
An additional rinse aid indicator light is on the control
panel. When the rinse agent dispenser is empty, the
indicator light will glow and the level indicator will
show a silver background with black lines.
After filling the rinse agent dispenser, close the door
and wait a few minutes for the indicator light to regis-
ter.
Rinse Agent Dispenser Regulator
The rinse agent reservoir of the Thermador dishwasher
is provided with a regulator calibrated from 1 to 6.
(See Figure 15.) This regulator controls the amount
of rinse agent dispensed. The dishwasher leaves the
factory preset to 4. However,
NOTE: Refill rinse agent when the
level indicator shows a silver back-
ground with black lines.
Rinse agent is available in liquid or
solid form. Only use the liquid type
of rinse agent in the Thermador
dishwasher.
1. Open the dishwasher door fully.
2. Open the cover of the rinse agent dispenser by
pressing the star on the cover with your index
finger while pulling on the tab with your thumb.
3. Add rinse agent to the reservoir until the level
indicator turns dark, indicating that the reservoir
is full (capacity is approx. 3.5 oz.).
Adding Rinse Agent
• if you see streaks, you should turn the regulator to
a lower number.
• if you see water spots, you should turn the
regulator to a higher number.
To Fill the Rinse Agent Reservoir:
To adjust Rinse
Agent Regulator
Setting:
1. Open the cover
of the rinse agent
dispenser.
2.Turn the setting
indicator to the de-
sired setting.
Figure 15
Figure 16
Figure 17
Rinse agent level indicator
Page 10