Filter
Top Products
12
Wait at least ten seconds or until water noises
stop before opening the dishwasher door.
To resume the cycle, press the On/Off button and
shut the dishwasher door.
Selecting the Proper Wash Cycle
Always make sure your dishware is dishwasher
safe. Refer to the Dishware Materials section of
this manual for guidance.
Heavy Wash
Cleans items having baked-on or hard dried-on
food soils. These items may require soaking or
hand scouring.
Sens-a-Wash
Takes the guesswork out of cycle selection! The
sensors in the dishwasher automatically adjust
the cycle length, temperature and water changes
based on the soil load.
Normal Wash
Thoroughly cleans large loads having loosely
attached normal soiling.
Operating the Dishwasher
Starting the Dishwasher
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
Press the button for the desired wash cycle.
Shut the dishwasher door.
The dishwasher will start automatically and
continue operating until the end of the selected
cycle.
Once you start the dishwasher, leave the
dishwasher door shut until it finishes the cycle.
PowerBeam
Red LED illuminates the floor to indicate the unit
is running. When the cycle is complete the light
will go out.
Interrupting a Cycle
NOTE
: Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
is best to do so within the first 30 minutes of the
cycle.
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
To avoid damage to delicate or heirloom
items do not wash them in your dishwasher.
Light Wash
For delicate or heirloom dishware and silverware
or other special items. Always make sure that the
items are dishwasher safe. Refer to the
Materials section of this manual for further
information. Hand washing may be the best
treatment of such items.
Quick Wash
For lightly soiled items with easy to remove food
soils.
Rinse Only
Allows you to rinse the food soil off of a partial
load and hold them in the dishwasher until there
is a full load.
More information on dishwasher cycles is located
in the Wash Cycle Information section of this
manual.
Selecting Wash Cycle Options
PowerBoost
Reduces the time to complete a wash cycle by
preheating. To activate, select the PowerBoost
button in addition to the desired cycle.
WARNING
You could be seriously scalded if you open
the dishwasher door quickly during a wash
or rinse cycle. Do not fully open the
dishwasher door for at least 10 seconds or
until water noises stop.