Thermador PC48 Cooktop User Manual


 
The Thermador Professional
®
Cooktops are avail-
able in a number of sizes and configurations. Model
P24WK is a 24"-wide wok unit featuring a power
burner rated at 30,000 BTU/HR. The 36"-wide Mod-
els PC364GE, PC364GL, and PC366 feature four
sealed burners and an electric griddle, four sealed
burners and a gas grill, or six sealed burners,
respectively. The 48"-wide Models PC484GGE,
PC486GE, PC486GL and PC484WK feature four
sealed burners, electric griddle and gas grill, six
sealed burners and an electric griddle, six sealed
burners and a gas grill, or four sealed burners and
a 30,000 BTU/HR WOK, respectively. All sealed
burners are rated at 15,000 BTU/HR, electric
griddles at 1,600 watts, and grills at 18,000 BTU/HR.
IMPORTANT
A backguard must be utilized when there is
less than a 12" horizontal clearance between
combustible materials and the back edge of the
cooktop. The Thermador Low Back backguard
must be ordered separately and installed at the
rear of the cooktop. For island installations and
other installations with more than 12" clear-
ance, an optional stainless steel Island Trim is
available to cover the backguard mounting
flanges.
Verify that the appliance is correct for the type
of gas being provided. Refer to Step 4 before
proceeding with the installation.
Introduction
GAS SUPPLY:
Natural Gas – 6 inch water column.
Propane Gas – 11 inch water column.
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING
IMPORTANT: LOCAL CODES VARY. INSTALLATION, ELECTRICAL CONNECTIONS,
GAS CONNECTIONS, AND GROUNDING MUST COMPLY WITH ALL APPLICABLE CODES.
Model PC364GD
(Shown with Low Back Model GPS36LB)
Model P24WK
(Shown with Low Back Model GP24LB)
1
WARNING
Disconnect power before installing. Before
turning power ON, be sure that all controls are
in the OFF position.
ELECTRICAL POWER SUPPLY:
36" Models:
PC366- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
PC364GL- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
PC364GE
(with electric griddle)
- 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit
.
48" Models:
PC486GL- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
PC486GE- 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit.
PC486GGE
(with electric griddle)
- 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit
.
PC484WK- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
P24WK- 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit.
IMPORTANT:
Save these instructions for the Local Electrical Inspector’s use.
INSTALLER:
Please leave these Installation Instructions with this unit for the owner.
OWNER:
Please retain these instructions for future reference.